wsm L3301 Workshop Manual page 270

L3301, L3901, L4701, WSM
Pressure Plate Flatness
1. Place a straightedge on the pressure plate and measure
clearance with a feeler gauge at several points.
2. If the clearance exceeds the allowable limit, replace it.
3. When the pressure plate is worn around its outside and its
inside surface only is in contact with the straightedge, replace
even if the clearance is within allowable limit.
Clearance between
pressure plate and Allowable limit
straightedge
Pilot Bearing
1. Remove the pilot bearing in crank shaft with a puller.
2. Check for abnormal wear of pilot bearing.
3. Hold bearing inner race and rotate outer race. If the bearing
rotation is not smooth or it is noisy, replace bearing.
2-S23
CLUTCH
0.2 mm
0.008 in.
9Y1211012CLS0018US0
9Y1211012CLS0019US0
KiSC issued 09, 2016 A