wsm L3301 Workshop Manual page 348

L3301, L3901, L4701, WSM
Outer Components
1. Place the disassembling stands under the transmission case.
2. Remove the grips (3), (4), and (5).
3. Remove the lever guides (1) and (6).
4. Remove the center cover (12) and floor sheet cover (7).
5. Remove the rear wheels (11).
6. Remove the fender support (10).
7. Remove the fenders (9) and steps (13).
8. Remove the seat assembly (8).
(When reassembling)
Rear wheel mounting
Tightening torque
screw and nut
(1) Position Control Lever Guide
(2) Position Control Lever Grip
(3) Range Gear Shift Lever Grip
(4) Synchro-shuttle Shift Lever Grip
(5) Front Wheel Drive Lever Grip
(6) Shift Lever Guide
(7) Floor Sheet Cover
Fender Support and Delivery Pipe
1. Remove the fenders supports (2) and (3).
2. Disconnect the delivery pipe (1).
Delivery pipe mounting joint
Tightening torque
bolt
(1) Delivery Pipe
(2) Fender Support (RH)
Suction Pipe and Brake Rods
1. Remove the R.H. and L.H. brake rods (5).
2. Remove the oil filter base (4) with the filter and suction pipe (6).
3. Disconnect the PTO safety switch connector (3).
4. Remove the front wheel drive lever (2).
5. Remove the fender support (1).
(1) Fender Stay
(2) Front Wheel Drive Lever
(3) PTO Safety Switch Connector
Front Wheel Drive Case
1. Remove the front wheel drive case (1).
(When reassembling)
• Apply liquid gasket (Three Bond 1206C or equivalent) to both
faces of the gasket that is to be installed between the front drive
case and the transmission case.
(1) Front Wheel Drive Case
3-S36
TRANSMISSION
215 N·m
22 kgf·m
160 lbf·ft
(8) Seat Assembly
(9) Fender
(10) Fender Support
(11) Rear Wheel
(12) Center Cover
(13) Step
9Y1211012TRS0026US0
49 to 69 N·m
5.0 to7.0 kgf·m
37 to 50 lbf·ft
(3) Fender Support (LH)
9Y1211012TRS0027US0
(4) Oil Filter Base
(5) Brake Rod
(6) Suction Pipe
9Y1211012TRS0028US0
9Y1211012TRS0029US0
KiSC issued 09, 2016 A