wsm L3301 Workshop Manual page 189

L3301, L3901, L4701, WSM
Draining Transmission Fluid (L4701)
CAUTION
To avoid personal injury:
• Be sure to stop the engine before changing the oil filter
cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the drain plugs (1) at the bottom of the transmission
case and drain the oil completely into the oil pan.
2. After draining reinstall the drain plugs.
(When reassembling)
• Fill up new oil to the upper line of the gauge (2) from the oil inlet
port after removing the oil inlet plug (3).
• Operate the engine at medium speed for a few minutes, stop it
and check the fluid level again, if low, add fluid prescribed level
(A).
IMPORTANT
• Use only multi-grade transmission fluid. Use of other fluids
may damage the transmission or hydraulic system.
• Refer to "LUBRICANTS, FUEL AND COOLANT" on page
G-11.
• Never work the tractor immediately after changing the
transmission fluid. Keeping the engine at medium speed
for a few minutes to prevent damage to the transmission.
• Do not mix different brands oil together.
Transmission fluid Capacity
(1) Drain Plug
(2) Gauge
(3) Oil Inlet Plug
1-S26
ENGINE
40.0 L
10.6 U.S.gals
8.8 Imp.gals
[A] Manual Transmission Model
[B] HST Model
(A) Oil level is acceptable within this
range.
9Y1211012RAS0004US0
KiSC issued 09, 2016 A