wsm L3301 Workshop Manual page 478

L3301, L3901, L4701, WSM
Bevel Gear Case, Axle Flange and Front Gear Case
1. Remove the plug (4).
2. Remove the internal snap ring (3) and shim (2).
3. Remove the axle flange (1).
4. Tap out the bevel gear (6) and ball bearing.
5. Draw out the bevel gear shaft (7).
6. Remove the external snap ring (5).
7. Tap the bevel gear case (8), and separate it from the front gear
case (9).
(When reassembling)
• Apply grease to the O-rings of axle flange (1).
• Tighten the axle flange mounting screws and nuts diagonally in
several steps.
• Install the oil seal (10) of bevel gear case, noting its direction as
shown in the figure below.
Axle flange mounting stud
bolt
Tightening torque
Axle flange mounting bolts
and nuts
(1) Axle Flange
(2) Shim
(3) Internal Snap Ring
(4) Plug
(5) External Snap Ring
Bevel Gear Case Gears
1. Remove the internal snap ring (1).
2. Remove the bevel gears (5), (7) with ball bearings (4), (6), collar
(2) and shims (3).
(When reassembling)
• Install the same shims (3) have same thickness as before
disassembling.
(1) Internal Snap Ring
(2) Collar
(3) Shim
(4) Ball Bearing
6-S14
FRONT AXLE
12 to 15 N·m
1.2 to 1.6 kgf·m
8.7 to 11 lbf·ft
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
(6) Bevel Gear
(7) Bevel Gear Shaft
(8) Bevel Gear Case
(9) Front Gear Case
(10) Oil Seal
9Y1211012FAS0016US0
(5) Bevel Gear
(6) Ball Bearing
(7) Bevel Gear
(8) Bevel Gear Case
9Y1211012FAS0017US0
KiSC issued 09, 2016 A