Disassembling Front Axle [4Wd Type] - wsm M108S Workshop Manual

M108S, WSM

(2) Disassembling Front Axle [4WD Type]

Tie-rod
1. Pull out the cotter pin and remove the tie-rod end slotted nuts.
2. Remove the tie-rod with a tie-rod end lifter (Code No. 07909-
39051).
(When reassembling)
• Replace cotter pin with a new one.
• Bend the cotter pin as shown in the figure.
Tie-rod slotted nut
Tightening torque Tie-rod joint lock nut
Knuckle arm mounting
screw
(1) Tie-rod
(2) Knuckle Arm
Separation of Front Differential Case and Bevel Gear Case
1. Remove the bevel gear case (2) and the front wheel case (3) as
a unit from the front differential case (1).
(When reassembling)
• Apply grease to the O-ring.
• Install the bevel gear case to the front differential case, noting the
O-ring.
Bevel gear case mounting
screw (M12, UBS screw
9T)
Tightening torque
Bevel gear case mounting
screw
(M14, 7T)
(1) Front Differential Case
(2) Bevel Gear Case
6-S10
FRONT AXLE
157 to 196 N·m
16.0 to 20.0 kgf·m
116 to 144 lbf·ft
167 to 196 N·m
17.0 to 20.0 kgf·m
123 to 144 lbf·ft
124 to 147 N·m
12.6 to 15.0 kgf·m
91.2 to 108 lbf·ft
(3) Tie-rod End Lifter
W1015363
128 to 142 N·m
13.0 to 14.5 kgf·m
94.1 to 104 lbf·ft
124 to 147 N·m
12.6 to 15.0 kgf·m
91.2 to 108 lbf·ft
(3) Front Wheel Case
W1016047
KiSC issued 05, 2012 A