wsm L3301 Workshop Manual page 486

L3301, L3901, L4701, WSM
Bevel Gear and Bevel Gear Shaft
1. Remove the plug (5).
2. Remove the internal snap ring (4) and shim (3).
3. Tap out the bevel gear (2) with ball bearing.
4. Draw out the bevel gear shaft (1).
(1) Bevel Gear Shaft
(2) Bevel Gear
(3) Shim
Bevel Gear Case Gears
1. Remove the external snap ring (1).
2. Tap the bevel gear case (2) and separate it from the front gear
case (3).
3. Remove the internal snap ring (4).
4. Remove the bevel gears (5), (6) with ball bearings, and shims
(7).
(When reassembling)
• Install the shims (7) to their original position.
• Install the oil seal (8) of bevel gear case, noting its direction.
(1) External Snap Ring
(2) Bevel Gear Case
(3) Front Gear Case
(4) Internal Snap Ring
6-S22
FRONT AXLE
(4) Internal Snap Ring
(5) Plug
9Y1211012FAS0031US0
(5) Bevel Gear
(6) Bevel Gear
(7) Shim
(8) Oil Seal
9Y1211012FAS0032US0
KiSC issued 09, 2016 A