Disassembling Rear Axle Case - wsm M8540NARROW Workshop Manual

M8540Narrow, M9540Narrow, WSM

[3] DISASSEMBLING REAR AXLE CASE

Planetary Gear Support
1. Remove the retainer plate mounting screw (2) and retainer (1).
2. Remove the external circlip (3).
3. Carefully remove the planetary gear support (4).
4. Remove the internal gear (6) and pins (5).
(When reassembling)
• Be sure to insert the retainer plate (1).
Retainer plate mounting
Tightening torque
screw
(1) Retainer Plate
(2) Screw
(3) External Circlip
Planetary Gear
1. Tap the roll pin (1) into the planetary gear shaft (3).
2. Draw out the planetary gear shaft (3), and remove the planetary
gear (2).
3. Tap out the roll pin from the planetary gear shaft.
(When reassembling)
• Apply transmission fluid to the inner surface of planetary gear
(2).
• Tap in the roll pin (1) as shown in the figure.
(1) Roll Pin
(2) Planetary Gear
N4-S6
REAR AXLE
60.8 to 70.6 N·m
6.2 to 7.2 kgf·m
44.9 to 72.3 lbf·ft
(4) Planetary Gear Support
(5) Pin
(6) Internal Gear
9Y1210236RAS0010US0
(3) Planetary Gear Shaft
9Y1210236RAS0011US0
KiSC issued 07, 2013 A