wsm L3301 Workshop Manual page 208

L3301, L3901, L4701, WSM
Cylinder Head
1. Remove the cylinder head screw in the sequence of (n or r) to
(a).
2. Lift up the cylinder head (3) to remove.
3. Remove the cylinder head gasket (4).
(When reassembling)
• Replace the cylinder head gasket (4) with a new one.
• Apply sufficient oil and tighten the cylinder head screws.
• Tighten the cylinder head screws in a diagonal sequence. Start
from the center in the sequence of (a) to (n or r).
• Tighten them equally, or the shape of the head changes after
some time.
Cylinder head mounting
Tightening torque
screw
IMPORTANT
• Before you replace the cylinder head gasket (4), record the
mark (5) on the cylinder head gasket of the engine. Then
replace a cylinder head gasket with same mark.
Gasket Mark
and
D1803-CR-E4
Code Number
15 1G750-03600
20 1G750-03310
25 1G750-03610
30 1G750-03620
35 1G750-03630
(1) Water Return Pipe
(2) Pipe Clamp
(3) Cylinder Head
(4) Cylinder Head Gasket
(5) Mark
1-S45
ENGINE
93.2 to 98.0 N·m
9.50 to 10.0 kgf·m
68.8 to 72.3 lbf·ft
Model
V2403-CR-E4
1G790-03600
1G790-03310
1G790-03610
1G790-03620
1G790-03630
(n or r) to (a): To Loosen
(a) to (n or r): To Tighten
(A) Gear Case Side
(B) Flywheel Side
(To be continued)
KiSC issued 09, 2016 A