Testing, Setting And Adjusting By Electronic Instrument Panel; Mode Selection - wsm L3301 Workshop Manual

Hide thumbs Also See for L3301:

Table of Contents

L3301, L3901, L4701, WSM

[2] TESTING, SETTING AND ADJUSTING BY ELECTRONIC

INSTRUMENT PANEL

The following setting, adjustments and testing can be done by using the electronic instrumental panel.

• Testing: Check a voltage from various sensors or rotation of engine.

• Setting: Input various data to electronic instrumental panel or main ECU.

• Error Information: Check or clear the error information.

• To perform the testing of the electronic instrument panel,

operator must be seated on the tractor.

• When performing this testing, be sure to change gears to

neutral and apply parking brake.

1. While holding down both DPF INHIBIT switch (2) and Parked

regeneration switch (3), turn key switch to "ON" or "START"

2. Mode selection display is indicated on the LCD (4).

3. Press the parked regeneration switch (3) and the mode

indicated on LCD is changed.

4. The code of desired mode is indicated, press the parked

regeneration switch (3) for more than 2 seconds.

Error Information Clear Mode

Acceleration Sensor Fine-adjustment Mode

Tractor Model Select Mode

(1) Instrument Panel

(2) DPF INHIBIT Switch

ELECTRICAL SYSTEM

9Y1211012ELS0008US0

Detail of Made

(3) Parked Regeneration Switch

(4) LCD (Liquid Crystal Display)

9Y1211012ELS0009US0

KiSC issued 09, 2016 A

Chapters

Table of Contents