wsm L3301 Workshop Manual page 419

L3301, L3901, L4701, WSM
Clearance between Differential Pinion Shaft and Differential
Pinion
1. Measure the differential pinion shaft O.D.
2. Measure the differential pinion I.D. and calculate the clearance.
3. If the clearance exceed the allowable limit, replace them.
Factory specification
Clearance between
differential pinion shaft
and differential pinion
Allowable limit
Differential pinion shaft
Factory specification
O.D.
Differential pinion I.D. Factory specification
Backlash between Differential Pinion and Differential Side
Gear
1. Secure the differential case in a vise.
2. Set a dial indicator (lever type) on the tooth of the differential
side gear.
3. Hold the differential pinion and move the differential side gear to
measure the backlash.
4. If the measurement exceeds the allowable limit, adjust with the
differential side gear washer.
Factory specification
Backlash between
differential pinion and
differential side gear
Allowable limit
(Reference)
• Thickness of differential side gear washers:
1.5 mm (0.059 in.)
1.6 mm (0.062 in.)
1.7 mm (0.067 in.)
1.8 mm (0.071 in.)
2.0 mm (0.074 in.)
3-S107
TRANSMISSION
0.0800 to 0.122 mm
0.00315 to 0.00480 in.
0.25 mm
0.0098 in.
19.959 to 19.980 mm
0.78579 to 0.78661 in.
20.060 to 20.081 mm
0.78977 to 0.79059 in.
9Y1211012TRS0156US0
0.15 to 0.30 mm
0.0059 to 0.011 in.
0.4 mm
0.02 in.
9Y1211012TRS0157US0
KiSC issued 09, 2016 A