wsm L3301 Workshop Manual page 495

Hide thumbs Also See for L3301:

Table of Contents

L3301, L3901, L4701, WSM

Backlash between 11T Bevel Gear and 42T Bevel Gear

1. Place plastigauge or wire of solder to three spots on the 42T

bevel gear (1) with grease.

2. Fix the axle flange and front gear case.

3. Turn the axle.

4. Remove the axle flange from front gear case and measure the

thickness of the plastigauge with scale.

5. If the backlash is not within the factory specifications, adjust with

Factory specification

Backlash between bevel

gear (2) and bevel gear

Allowable limit

• Thickness of adjusting shims:

1.0 mm (0.039 in.)

1.2 mm (0.047 in.)

1.4 mm (0.055 in.)

1.6 mm (0.063 in.)

1.8 mm (0.071 in.)

2.0 mm (0.079 in.)

2.2 mm (0.087 in.)

• Tooth contact:

More than 10 %

• Center of tooth contact:

1/10 to 1/5 of the entire width from the small end.

(1) Bevel Gear

(2) Bevel Gear

0.15 to 0.30 mm

0.006 to 0.012 in.

9Y1211012FAS0047US0

KiSC issued 09, 2016 A

Chapters

Table of Contents