wsm L3301 Workshop Manual page 657

L3301, L3901, L4701, WSM
Rear End Frame
1. Remove the two nuts and two screws holding the drive end
frame and the rear end frame.
2. Remove the rear end frame (1).
(1) Rear End Frame
Rotor
1. Press out the rotor (1) from drive end frame (3).
IMPORTANT
• Be very careful not to drop the rotor and damage the slip
ring or fan, etc..
(1) Rotor
(2) Block
Retainer Plate
1. Remove the four screws holding the retainer plate, and remove
the retainer plate (1).
(1) Retainer Plate
Bearing on Drive End Side
1. Press out the bearing from drive end frame (3) with a press and
jig (1).
(1) Jig
(2) Block
Bearing at Slip Ring Side
1. Lightly secure the rotor (1) with a vise to prevent damage, and
remove the bearing (2) with a puller (3).
(1) Rotor
(2) Bearing
9-S58
ELECTRICAL SYSTEM
WSM000001ELS0028US0
(3) Drive End Frame
WSM000001ELS0029US0
WSM000001ELS0030US0
(3) Drive End Frame
WSM000001ELS0031US0
(3) Puller
WSM000001ELS0032US0
KiSC issued 09, 2016 A