wsm L3301 Workshop Manual page 381

L3301, L3901, L4701, WSM
[C] Separating Transmission Case
Draining Transmission Fluid (L4701)
CAUTION
To avoid personal injury:
• Be sure to stop the engine before changing the oil filter
cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the drain plugs (1) at the bottom of the transmission
case and drain the oil completely into the oil pan.
2. After draining reinstall the drain plugs.
(When reassembling)
• Fill up new oil to the upper line of the gauge (2) from the oil inlet
port after removing the oil inlet plug (3).
• Operate the engine at medium speed for a few minutes, stop it
and check the fluid level again, if low, add fluid prescribed level
(A).
IMPORTANT
• Use only multi-grade transmission fluid. Use of other fluids
may damage the transmission or hydraulic system.
• Refer to "LUBRICANTS, FUEL AND COOLANT" on page
G-11.
• Never work the tractor immediately after changing the
transmission fluid. Keeping the engine at medium speed
for a few minutes to prevent damage to the transmission.
• Do not mix different brands oil together.
Transmission fluid Capacity
(1) Drain Plug
(2) Gauge
(3) Oil Inlet Plug
Battery Negative Cable
1. Open the bonnet and disconnect the battery negative cable
from the battery.
(When reassembling)
NOTE
• When connecting the battery cords, connect the battery
positive cable first.
(1) Battery Negative Cable Connector
3-S69
TRANSMISSION
40.0 L
10.6 U.S.gals
8.8 Imp.gals
[A] Manual Transmission Model
[B] HST Model
(A) Oil level is acceptable within this
range.
9Y1211012RAS0004US0
9Y1211012TRS0081US0
KiSC issued 09, 2016 A