L3301, L3901, L4701, WSM
[2] HYDRAULIC CYLINDER
Battery Negative Cable
1. Open the bonnet.
2. Remove the battery negative cable (1).
(1) Battery Negative Cable
Lift Rod
1. Remove the top link (1).
2. Remove the rubber spring (2).
3. Remove the lift rods (3).
(1) Top Link
(2) Rubber Spring
Outer Components
1. Remove the seat (1).
2. Remove the grips (2), (3), (4), (7).
3. Remove the lever guides (5).
4. Remove the PTO switch (6).
(1) Seat
(2) Grip
(3) Grip (Shuttle Lever)
[Manual Transmission Model Only]
(4) Grip (4WD Lever)
[4WD Model Only]
(5) Lever Guide
Suspension Seat
1. Remove the floor seat cover (1).
2. Remove the center cover (2).
3. Remove the suspension seat (3).
4. Remove the joint bolt (4).
5. Remove the wiring (5).
Delivery pipe (hydraulic
Tightening torque
block) joint bolt
(1) Floor Seat Cover
(2) Center Cover
(3) Suspension Seat
8-S20
HYDRAULIC SYSTEM
9Y1211012HYS0009US0
(3) Lift Rod
9Y1211012HYS0010US0
(6) PTO Switch [L4701 Only]
(7) Grip (Cruise Lever)
[L4701 HST Model Only]
[A] L3301/L3901
[B] L4701
9Y1211012HYS0011US0
49 to 69 N·m
5.0 to 7.0 kgf·m
37 to 50 lbf·ft
(4) Joint Bolt
(5) Wiring
9Y1211012HYS0012US0
KiSC issued 09, 2016 A