wsm L3301 Workshop Manual page 272

L3301, L3901, L4701, WSM
Release Lever Height
1. Mount the dual stage clutch exclusive tool (Code No.
07916-90052).
2. Measure the clearance between gauge ring and the top of
adjusting screw with a feeler gauge.
3. If the clearance is not within the factory specifications, adjust
with the adjusting screws.
Clearance between
gauge ring and the top of Factory specification
adjusting screw
Tightening torque Adjusting screw lock nut
IMPORTANT
• Be sure to adjust the mutual difference of release lever to
within the factory specifications.
NOTE
• Apply adhesive (Cemdine No. 110 by Cemdine Industry Co.,
Ltd. or equivalent) to the adjusting screws, replace lever
and lock nuts.
(Reference)
Release lever height h Reference value
Clearance between Pressure Plate 2 and Adjusting Screw
1. Measure the clearance between pressure plate 2 and the top of
adjusting screw with a feeler gauge.
2. If the clearance is not within the factory specifications, rotate
adjusting screw to adjust.
Clearance between
pressure plate 2 and Factory specification
adjusting screw
Pressure plate 2 height
Tightening torque
adjusting screw lock nut
2-S25
CLUTCH
0 to 0.7 mm
0 to 0.003 in.
16 to 21 N·m
1.6 to 2.2 kgf·m
12 to 15 lbf·ft
97.8 to 99.2 mm
3.85 to 3.90 in.
9Y1211012CLS0025US0
0.90 to 1.0 mm
0.036 to 0.039 in.
16 to 21 N·m
1.6 to 2.2 kgf·m
12 to 15 lbf·ft
9Y1211012CLS0026US0
KiSC issued 09, 2016 A