wsm L3301 Workshop Manual page 354

L3301, L3901, L4701, WSM
Main Shaft and PTO Counter Shaft
1. Remove the screws (1), (2) and remove the spring (3) and ball
(4).
2. Tap out the spring pin (5).
3. Draw out the fork rod (7) to front.
4. Remove the shift fork (6).
5. Remove the bearing cover (15).
6. Remove external circlip (32).
7. Tap in PTO counter shaft (19) to front side.
8. Remove bearing (9).
9. Tap out main shaft (8) to rear side.
10. Remove external snap ring (16).
11. Tap out PTO counter shaft (19) to rear and remove 45T gear
(27).
(When reassembling)
• Be careful not damage or lose ball (4) and spring (3).
• Apply molydeum disulfide (Three Bond 1091 or equivalent) to
the inner circumferential surface of spline boss (23).
• Point the oil grove side of thrust collar (29) towards the spline
boss.
• Bearing cover (15) should be replaced with new one.
(1) Screw
(2) Screw
(3) Spring
(4) Ball
(5) Spring Pin
(6) Shift Fork
(7) Fork Rod
(8) Main Shaft
(9) Bearing
(10) 21T Gear
(11) 23T Gear
(12) Collar
(13) Bearing
(14) O-ring
(15) Bearing Cover
(16) External Snap Ring
3-S42
TRANSMISSION
(17) Collar
(18) Bearing
(19) PTO Counter Shaft
(20) PTO Clutch Cam 1
(21) Circlip
(22) PTO Clutch Cam 2
(23) Spline Boss
(24) Spring
(25) Washer
(26) Circlip
(27) 45T Gear
(28) Circlip
(29) Thrust Collar
(30) Ball Bearing
(31) Washer
(32) External Circlip
9Y1211012TRS0039US0
KiSC issued 09, 2016 A