wsm L3301 Workshop Manual page 379

L3301, L3901, L4701, WSM
[B] Separating Clutch Housing and Mid Case
Outer Components
1. Remove the mounting bolts and the steering support (1).
2. Disconnect the differential lock pedal.
3. Remove the step (2) and the main wiring harness.
(1) Steering Support
Suction Pipe and Hydraulic Block
1. Remove the suction pipe (5).
2. Remove the hydraulic block (3).
3. Remove 3P delivery pipe (1).
4. Remove the brake connecting rod R.H. (4) and L.H..
(When reassembling)
• Apply grease to the O-rings.
3P delivery pipe joint bolt
Tightening torque
3P delivery pipe mounting
M8 bolt
(1) 3P Delivery Pipe
(2) Oil Filter
(3) Hydraulic Block
Separating Clutch Housing Case from Mid Case
1. Loosen and remove the screws and the nuts securing the clutch
housing case (1) to mid case (2).
2. Separate the clutch housing case (1) from the mid case (2).
(When reassembling)
• Replace the gasket with a new one.
Clutch housing case and
Tightening torque mid case mounting screw
and nut
(1) Clutch Housing Case
3-S67
TRANSMISSION
(2) Step
9Y1211012TRS0074US0
49.0 to 69.0 N·m
5.0 to 7.0 kgf·m
36.2 to 50.6 lbf·ft
23.5 to 24.7 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
(4) Brake Connecting Rod (R.H.)
(5) Suction Pipe
9Y1211012TRS0075US0
102.9 to 117.6 N·m
10.5 to 12.0 kgf·m
75.9 to 86.8 lbf·ft
(2) Mid Case
9Y1211012TRS0076US0
KiSC issued 09, 2016 A