wsm L3301 Workshop Manual page 484

L3301, L3901, L4701, WSM
Knuckle Shaft and Outer Front Axle
1. Remove the knuckle arm (1) and draw out the knuckle shaft (2)
from the front axle.
2. Remove the outer front axle (3).
(When reassembling)
• Apply grease to the knuckle shaft (2) and thrust collar (4), (5).
• Do not interchange right and left knuckle arms.
• Be sure to install the thrust collars (4), (5) so that groove side is
downward.
• Be sure to align the hole of thrust collars (4), (5) and knock pin
(6), (7).
• A large size thrust collar (5) must be lower side.
Knuckle arm mounting bolt
and nut
Tightening torque
Outer front axle mounting
bolt and nut
(1) Knuckle Arm
(2) Knuckle Shaft
(3) Outer Front Axle
(4) Thrust Collar
Steering Cylinder
1. Remove the clamps (4) and remove the steering cylinder (2).
(1) Bracket, Front
(2) Steering Cylinder
(3) Middle Front Axle
6-S20
FRONT AXLE
77.5 to 90.2 N·m
7.9 to 9.2 kgf·m
57.2 to 66.5 lbf·ft
123 to 147 N·m
12.6 to 15.0 kgf·m
91.1 to 108.5 lbf·ft
(5) Thrust Collar
(6) Knock Pin
(7) Knock Pin
9Y1211012FAS0026US0
(4) Clamp
(5) Bracket, Rear
9Y1211012FAS0027US0
KiSC issued 09, 2016 A