Adjustment After Installing The Finisher; How To Check And Adjust The Side-To-Side Registration - Ricoh D197 Service Manual

2.15.3 ADJUSTMENT AFTER INSTALLING THE FINISHER

After installing a finisher, make sure that the Side-to-Side registration of the finisher matches that
of the main machine.

How to Check and Adjust the Side-to-Side Registration

Check the side-to-side registration by exiting to the proof tray. Print out an A3 sheet to the proof
tray. Using the markings on the front-most exit roller, check to see where the paper edge is
located when the paper is exited. For purposes of accuracy, print out about 5 sets. If side-to-side
registration shift occurs, see the Troubleshooting section and make adjustments (page 6-189).
[A]: Scale marks for DLT
[B]: Scale marks for A3
[C]: 7 scale marks at 2mm intervals
[D]: Center mark

Each marking represents 2mm.

If the paper edge is lined up with the center marking, this means the paper is aligned
correctly.

If the paper edge is lined up with any marking to the right of center, this means the
paper is shifted toward the front.

If the paper edge is lined up with any marking to the left of center, this means the
paper is shifted toward the rear.
SM
Booklet Finisher SR3170 / Finisher SR3160
2-101 D197/D198/D199/D200/D201/D202