After Installing The New Pm Parts; Operation Check - Ricoh D197 Service Manual

PM Parts Settings
4. Exit the SP mode.
5. Turn off the main power.
6. Replace the PM parts and turn the power on
The machine will reset the PM counters and the remaining day counters. The machine will
also do the developer initialization..

After the PM counter for the Fusing Belt (heating sleeve belt unit) reaches its PM cycle,
the machine stops the operation automatically. Replace the heating sleeve belt unit
before the machine stops its operation (stop warning: 240K pages, stop: 260K pages for
D197/D198/D199, stop warning: 320K pages, stop: 350K pages for D200/D201/D202).

3.4.2 AFTER INSTALLING THE NEW PM PARTS

1. Turn on the main power.
2. Output the SMC logging data with SP5-990-004 and check the counter values.
3. Make sure that the PM counters for the replaced units are "0" with SP7-621 and
SP7-944. If the PM counter for a unit has not been reset, then reset that counter with SP
7-622.

3.4.3 OPERATION CHECK

Check if the sample image has been copied normally.
D197/D198/D199/D200/D201/D202 3-10 SM