Ricoh D197 Service Manual page 234

Smart Operation Panel Type M3
12. Change the SP modes below.
Change the setting of bit 0 in System SP5-752-001 to "1".
Change the setting of bit 0 in Scanner SP1-041-001 to "1".
If fax option is installed,
Change the setting of bit 0 in Fax SP3-301-001 to "1".
13. Turn the main power OFF/ON. If it is connected normally, the default setting icons are
displayed.
⇒
14. Download package firmware (D2015506*) for SOP model from firmware download
center. If the SD card is blank, make the "Package" folder onto the SD card, and copy
the package firmware on to there.
⇒
15. Insert the SD card into SD Card Slot 2 (Lower Slot) and turn the main switch on.
⇒
16. The alert message appears after turning the main switch on due to difference of
firmware part number, and press OK button.
⇒
17. Select package file and update controller soft version.
⇒
18. Turn the main switch off-on, check to see if the updating is done in user tool
(User tool > system Setting > Administrator Setting >Firmware Version).
D197/D198/D199/D200/D201/D202 2-164
Rev. 1/16/2015
SM