Procedure - Ricoh D197 Service Manual


Even when not using a RPCS driver, the XPS driver requires RPCS firmware.

5.20.3 PROCEDURE


A SD card is a precision device, so when you handle an SD card, respect the following.

When the power is switched ON, do not insert or remove a card.

During installation, do not switch the power OFF.

Since the card is manufactured to high precision, do not store it in a hot or humid location,
or in direct sunlight.

Do not bend the card, scratch it, or give it a strong shock.

Before downloading firmware on an SD card, check whether write-protection of the SD
card is canceled. If write-protection is enabled, an error code (error code 44, etc.) will be
displayed during download, and the download will fail.

Before updating firmware, remove the network cable from this machine.

If SC818 is generated during software update, switch the power OFF -> ON, and
complete the update which was interrupted.

During software update, network cables, remove interface cables, wireless boards, etc.,
(so that they are not accessed during update).
SM 5-411 D197/D198/D199/D200/D201/D202
Firmware Update