Test Pattern Printing - Ricoh D197 Service Manual

Test Pattern Printing

5.19 TEST PATTERN PRINTING
Printing Test pattern: SP2-109
Some of these test patterns are used for copy image adjustments but most are used primarily for
design testing.

Do not operate the machine until the test pattern is printed out completely. Otherwise, SC
will occur.
1. Enter the SP mode then select SP2-109-003 "Pattern Selection".
2. Select test pattern for print from the list then press [OK].
3. To change the density of the test pattern, select the density with SP2-109-006, then
press [#].

If select "0" with SP2-109-006, the color adjusted so will not show up in the test
pattern.
4. To print, touch [Copy Window], then set settings within the following window for test
print (paper size etc...).
5. Press "Start" key to start test print.
6. After checking test pattern, touch "SP Mode" on the LCD to return to SP mode display.
7. Reset all settings to the default values (SP2-109-003, SP2-109-006).
8. Exit SP mode.
No.
0 None
1 1dot Vertical Line
2 2dot Vertical Line
3 1dot Horizontal Line
4 2dot Horizontal Line
5 Grid Vert (Grid Vert ical Line)
6 Grid Horizontal (Grid Horizontal Line)
7 Grid Pattern Small
8 Grid Pattern Large
D197/D198/D199/D200/D201/D202
Pattern No.
4dot Ind. Pttrn (4dot Independent
13
Pattern)
14 Trimming Area
15 Hounds tooth H
16 Hounds tooth V
17 Black Band H (Horizontal)
18 Black Band V (Vertical)
19 Checker Flag Pattern
20 Grayscale V (Vertical)
21 Grayscale H (Horizontal)
5-408
Pattern
SM