When you lift the machine, be sure to hold the grips on the machine.
In particular, do not lift the machine by holding the scanner unit, etc., because this
may cause the machine to deform.
Do not put the machine down on the paper feed unit as a temporary resting place.
This may cause the paper feed unit to deform. Always connect the machine and
paper feed unit properly.
4.
Pull out the 2nd paper feed tray of the machine.
5.
Using a securing bracket as a screwdriver, secure the machine to the LCT unit (spring
washer: screw: M4×10: 1).
6.
Attach the securing brackets [A] to two positions on the left and right at the rear of the
machine (screws: 1 each).
If the anti-condensation heater for this optional tray is to be installed, connect its
heater harness prior to this step (step 6) (page 2-192).
If "LCIT RT3030" is to be installed, connect its harness prior to this step (step 6)
(page 2-44).
SM
2-39
D197/D198/D199/D200/D201/D202
LCIT PB3170/ PB3230