Staple Setting As An Initial Setting - Ricoh D197 Service Manual

Internal Finisher SR3180
30. Connect the interface cable [A].
31. Attach the nylon clamp [A] as shown below (tapping screw 4x8: x1).
32. Turn the main power ON.
33. Ensure that the operation panel displays finisher jobs properly and that it works
properly.

Staple Setting as an Initial Setting


To adjust the strength of crimp between sheets of paper stapled, there is a setting which
makes single/ double staple changeable into each other.

The power of crimp is weakened when there is an image (toner) on the point where is to
be stapled. There also is a setting to mask the image on the point for staple, in order to
avoid the strength of crimp to be weakened.

Depending on users demands, explain the settings/ methods of the settings by checking
the following instruction.
D197/D198/D199/D200/D201/D202 2-144 SM