2.2.6 CHECK IMAGE QUALITY / SETTINGS
Loading Paper
When there are other options to be installed, install according to the procedure for each.
1.
Connect the power plug to the wall socket.
2.
Turn the main power ON.
3.
Check that the operation panel shows the following display.
"Please supply the tray with paper."
4.
Square the paper and load it print side up.
5.
The paper size is basically detected automatically.
1. Pull out the paper feed tray slowly until it stops.
2. While pressing the release lever, adjust the side fence to the paper size to be set.
3. Set the end fence.
Checking the copy image with the test chart
Check the copy image with the test chart.
SP Settings
1.
Go into the SP mode.
2.
Do SP5-181 and SP1-007-001 to change automatic paper size selection for the upper
tray, lower tray, and by-pass tray if necessary.
Upper Tray (Size Adjust Tray 1)
5-181-001
Tray 1: 1
5-181-002
Tray 1: 2
5-181-003
Tray 1: 3
5-181-004
Tray 1: 4
Lower Tray (Size Adjust Tray 2)
5-181-005
Tray 2: 1
5-181-006
Tray 2: 2
5-181-007
Tray 2: 3
5-181-008
Tray 2: 4
SM
0: A4LEF or 1: LT LEF
0: A3 or 1: DLT
0: B4 or 1: LG
0: B5 LEF or 1: Exe LEF
0: A4LEF or 1: LT LEF
0: A3 or 1: DLT
0: B4 or 1: LG
0: B5 LEF or 1: Exe LEF
2-23
D197/D198/D199/D200/D201/D202
Main Machine Installation