Ricoh D197 Service Manual page 918

bit 3 PCL/PS bypass tray paper rotation
(SEF/LEF)
This bitsw causes the device to revert to the behavior of previous
generations. It only takes effect if "Bypass Tray Setting Priority" =
"Driver/Command".
Previous spec (bitsw=1): If a standard sized paper mismatch occurred in the
bypass tray, the MFP always prompted for SEF paper.
If this bitsw=0 (default) then in the event of a standard sized paper mismatch,
the MFP will always prompt for paper of the rotation (SEF/LEF) determined
by the MFP bypass tray paper setting or by the bypass tray sensor.
bit 4 Timing of the PJL Status ReadBack (JOB
END) when printing multiple collated
copies.
This bitsw determines the timing of the PJL USTATUS JOB END sent when
multiple collated copies are being printed.
0 (default): JOB END is sent by the device to the client after the first copy has
completed printing. This causes the page counter to be incremented after the
first copy and then again at the end of the job.
1: JOB END is sent by the device to the client after the last copy has finished
printing. This causes the page counter to be incremented at the end of each
job.
bit 5 Display UTF-8 text in the operation panel
Enabled (=0):
Text composed of UTF-8 characters can be displayed in the operation panel.
Disabled (=1):
UTF-8 characters cannot be displayed in the operation panel.
For example, job names are sometimes stored in the MIB using UTF-8
encoded characters. When these are displayed on the operation panel, they
will be garbled unless this BitSw is enabled (=0).
SM
Disabled
Disable
Enabled
5-343 D197/D198/D199/D200/D201/D202
Printer SP Mode
Enabled
Enable
Disabled