Smartcard Trips; Table 9-4 Trip Conditions - Emerson unidrive sp User Manual

Safety Product Mechanical
Information Information Installation
9.5

SMARTCARD trips

After an attempt to read, write or erase data to or from a SMARTCARD a trip may occur if there has been a problem with the command. The following
trips indicate various problems as detailed in Table 9-4.

Table 9-4 Trip conditions

Trip
C.Acc SMARTCARD trip: SMARTCARD Read / Write fail
Check SMARTCARD is installed / located correctly
185 Ensure SMARTCARD is not writing data to data location 500 to 999
Replace SMARTCARD
SMARTCARD trip: The menu 0 parameter modification cannot be saved to the SMARTCARD because the necessary file has
C.boot
not been created on the SMARTCARD
A write to a menu 0 parameter has been initiated via the keypad with Pr 11.42 set to auto(3) or boot(4), but the necessary file on the
SMARTCARD has not been created
177
Ensure that Pr 11.42 is correctly set and reset the drive to create the necessary file on the SMARTCARD
Re-attempt the parameter write to the menu 0 parameter
C.bUSY SMARTCARD trip: SMARTCARD can not perform the required function as it is being accessed by a Solutions Module
178 Wait for the Solutions Module to finish accessing the SMARTCARD and then re-attempt the required function
C.Chg SMARTCARD trip: Data location already contains data
Erase data in data location
179
Write data to an alternative data location
C.Cpr SMARTCARD trip: The values stored in the drive and the values in the data block on the SMARTCARD are different
188
Press the red
C.dat SMARTCARD trip: Data location specified does not contain any data
183 Ensure data block number is correct
C.Err SMARTCARD trip: SMARTCARD data is corrupted
Ensure the card is located correctly
182 Erase data and retry
Replace SMARTCARD
C.Full SMARTCARD trip: SMARTCARD full
184 Delete a data block or use a different SMARTCARD
C.Optn SMARTCARD trip: Solutions Modules installed are different between source drive and destination drive
Ensure correct Solutions Modules are installed
Ensure Solutions Modules are in the same Solutions Module slot
180
Press the red
C.Prod SMARTCARD trip: The data blocks on the SMARTCARD are not compatible with this product
Erase all data on the SMARTCARD by setting Pr xx.00 to 9999 and pressing the red
175
Replace SMARTCARD
C.rdo SMARTCARD trip: SMARTCARD has the Read only bit set
Enter 9777 in Pr xx.00 to allow SMARTCARD Read / Write access
181
Ensure the drive is not writing to data locations 500 to 999 on the card
Unidrive SP User Guide
Issue Number: 13
Electrical Getting Basic
installation Started parameters the motor
reset button
reset button
www.controltechniques.com
Running SMARTCARD
Optimization
operation
Diagnosis
Onboard Advanced Technical
Diagnostics
PLC parameters Data
reset button
UL Listing
Information
155