Figure 3-29 Through-Panel Mounting The Size 6 Drive - Emerson unidrive sp User Manual

Safety Product Mechanical
Information Information Installation

Figure 3-29 Through-panel mounting the size 6 drive

310mm (12.205in)
(44.528in)
NOTE
In order to achieve IP54 rating (NEMA 12) for through-panel mounting, an IP54 insert must be installed (size 1 and 2) and the heatsink fan should be
replaced with an IP54 rated fan (sizes 1 to 4). Additionally, the gasket provided should be installed between the drive and the backplate to ensure a
good seal for the enclosure. If the heatsink mounted braking resistor is to be used with the drive through-panel mounted, refer to section 3.11 Internal
/ heatsink mounted braking resistor on page 60 prior to mounting the drive. For further information refer to section 3.9 Enclosing standard drive for
high environmental protection on page 50.
46
Electrical Getting Basic
installation Started parameters
298mm (11.732in)
200mm (7.874in)
1131mm 1179.3mm
(46.429in)
www.controltechniques.com
Running SMARTCARD
Optimization
the motor operation
98mm
(3.858in)
(1.067 0.020in)
1105.6mm
(43.528in)
(0.539 0.020in)
Onboard Advanced Technical
PLC parameters Data
258.6 0.5mm ±
(10.181 0.020in) ±
27.1 0.5mm ±
±
286.0 0.5mm ±
(11.260 0.020in) ±
1107.8 0.5mm ±
(43.614 0.020in) ±
R6.5mm
(0.256in)
13.7± 0.5mm
±
258.6 0.5mm ±
(10.181 0.020in) ±
Unidrive SP User Guide
UL Listing
Diagnostics
Information
∅8.5mm
(0.335in)
R6.5mm
(0.256in)
1161.2
± 0.5mm
(45.717
± 0.020in)
∅8.5mm
(0.335in)
Issue Number: 13