Figure 4-15 Use Of The Emc Bracket On Size 0; Figure 4-16 Installation Of Grounding Clamp (Size 1 And 2); Figure 4-17 Installation Of Grounding Clamp (Size 3); Figure 4-18 Installation Of Grounding Bracket (Size 0) - Emerson unidrive sp User Manual

Safety Product Mechanical
Information Information Installation
• See Figure 4-15 for details of installing the grounded metal panel on
size 0 drives.
• See Figure 4-16 and Figure 4-17 for details on installing the
grounding clamp.
• See Figure 4-18 and Figure 4-19 for details on installing the
grounding bracket.

Figure 4-15 Use of the EMC bracket on size 0

Figure 4-16 Installation of grounding clamp (size 1 and 2)

Figure 4-17 Installation of grounding clamp (size 3)

82
Electrical Getting Basic
installation Started parameters
www.controltechniques.com
Running SMARTCARD
Optimization
the motor operation

Figure 4-18 Installation of grounding bracket (size 0)

Figure 4-19 Installation of grounding bracket (sizes 1 to 6)

Loosen the ground connection nuts and slide the grounding bracket in
the direction shown. Once in place, re-tighten the ground connection
nuts.
On size 1 and 2, the grounding bracket is secured using the
power ground terminal of the drive. Ensure that the supply
ground connection is secure after installing / removing the
grounding bracket. Failure to do so will result in the drive not
WARNING
being grounded.
A faston tab is located on the grounding bracket for the purpose of
connecting the drive 0V to ground should the user require to do so.
When a size 4 or 5 is through-panel mounted, the grounding link bracket
must be folded upwards. A screw can be used to secure the bracket or it
can be located under the mounting bracket to ensure that a ground
connection is made. This is required to provide a grounding point for the
grounding bracket as shown in Figure 4-20.
Onboard Advanced Technical
Diagnostics
PLC parameters Data
Unidrive SP User Guide
Issue Number: 13
UL Listing
Information