Nv Media Card Parameters; Nv Media Card Trips - Emerson unidrive m200 User Manual

Safety Product Mechanical
information information installation
9.3

NV Media Card parameters

Table 9-2 Key to parameter table coding
RW Read / Write
RO Read only
Num Number parameter
Bit Bit parameter
Txt Text string
Bin Binary parameter
FI Filtered
11.036 NV Media Card File Previously Loaded
RO Num
Ú
0 to 999
This parameter shows the number of the data block last transferred from
an SD card to the drive. If defaults are subsequently reloaded this
parameter is set to 0.
11.037 NV Media Card File Number
RW Num
Ú
0 to 999
This parameter should have the data block number which the user would
like the information displayed in Pr 11.038, Pr 11.039.
11.038 NV Media Card File Type
RO Txt ND
Ú
0 to 2
Displays the type of data block selected with Pr 11.037.
Pr 11.038 String
0 None
1 Open-loop
2 RFC-A
11.039 NV Media Card File Version
RO Num ND
Ú
0 to 9999
Displays the version number of the file selected in Pr 11.037.
11.042 Parameter Cloning
RW Txt
None (0), Read (1), Prog
Ú
(2), Auto (3),
Boot (4)
9.4

NV Media Card trips

After an attempt to read, write or erase data from a NV Media Card a trip
is initiated if there has been a problem with the command.
See Chapter 12 Diagnostics on page 179 for more information on NV
Media Card trips.
Unidrive M200 / M201 User Guide
Issue Number: 4
Electrical Getting Basic
installation started parameters
ND No default value
NC Not copied
PT Protected parameter
RA Rating dependant
US User save
PS Power-down save
DE Destination
NC PT
Ö
0
Ö
0
NC PT
Ö
0
Type / mode
No file selected
Open loop mode parameter file
RFC-A mode parameter file
NC PT
Ö
0
NC
Ö
0
Running the NV Media
Optimization
motor
US*
Advanced Technical
Diagnostics
Card parameters data
UL Listing
99