NA (Network Analyzer) Mode
NA Mode Settings
Quick Settings
Both CAT and NA Modes allow you to view and change most relevant settings
from a single location. All of these settings are discussed in this chapter and,
unless otherwise noted, ALL of these settings can also be made using the
standard softkey menus. In the graphic below, the resolution is being edited.
Interference Rejection and System Z0 can be changed ONLY from the
Quick Settings menu. Learn more about these settings in
Impedance (Z0)" on page 54
the standard softkey menus.
How to view and change Quick Settings
— Press Meas Setup 4
— Then Settings.
— Press
— To change a setting:
— Press
Keysight N9923-90001 User's Guide
Next Page
Previous Page
and
are NOT available, then all available settings fit on one page.
—Use the
arrows to highlight a setting.
Ed
it. The current setting changes to yellow.
—Then press
—Some settings require you to press a softkey to change the value.
Otherwise, use the numeric keypad,
change the value.
—When finished changing a value, press
Dock Window
to relocate the Settings table to a position relative to
the trace window. The Dock Window setting persists through a Preset.
Choose from the following:
ALL other settings can also be made using
.
to view all settings. If these softkeys
arrows, or rotary knob to
Done
Edit.
"System
45