Quick Settings - Keysight N9923A FieldFox User Manual

How to maximize the viewing of the active trace
 Press System 7
 Then
 Press any key to return to the standard display.

Quick Settings

Both NA and CAT Modes allow you to view and change most relevant settings from a
single location.
The Quick Settings menu. The resolution is being edited.
NOTE Interference Rejection and System Z0 can be changed ONLY from the Quick Settings
menu. Learn more about these settings on pages 31 and 32. ALL other settings can
also be made using the standard softkey menus.
How to view and change Quick Settings
 Press Meas Setup 4.
 Then Settings.
 Press
 To change a setting:
 Press
NA (Network Analyzer) Mode
Full Screen
and
Next Page Previous Page
NOT available, then all available settings fit on one page.
Use the ▲|▼ arrows to highlight a setting.
o
Then press Edit. The current setting changes to
o
Some settings require you to press a softkey to change the value. Otherwise, use
o
the numeric keypad, ▲|▼ arrows, or rotary knob to change the value.
When finished changing a value, press
o
to relocate the Settings table to a position relative to the
Dock Window
trace window. The Dock Window setting persists through a Preset. Choose from
the following:
Full (Default setting) Only the Settings table is shown on the screen. The trace
o
window is temporarily not shown.
Left The Settings table is shown to the left of the trace window.
o
to view all settings. If these softkeys are
yellow.
Done Edit.
25