Management Port Leds In J-Ex4500 Switches - Dell PowerConnect J-EX4500 Hardware Manual

Dell PowerConnect J-Series J-EX4500 Ethernet Switch Hardware Guide
Table 8: Status LED on Network Ports and Uplink Module Ports in J-EX4500 Switches
LED
Status
Related
Documentation

Management Port LEDs in J-EX4500 Switches

20
The Status LED in Figure 7 on page 19 and Figure 8 on page 19 indicate the status of one
of the three port parameters. The port parameters are administrative status, duplex
mode, and speed.
Table 8 on page 20 describes the Status LED on network ports and uplink module ports
in J-EX4500 switches. From the Idle menu of the LCD, use the
panel to toggle between the ADM, DPX, and SPD indicators.
LCD Indicator
LED: ADM
LED: DPX
LED: SPD
Front Panel of a J-EX4500 Switch on page 8
Uplink Modules in J-EX4500 Switches on page 27
The management port on the front panel of a J-EX4500 switch has two LEDs that indicate
link/activity and port status (see Figure 9 on page 21).
State and Description
Indicates the administrative status (enabled or disabled).
The status indicators are:
Green—Port is administratively enabled.
Unlit—Port is administratively disabled.
Indicates the duplex mode.
The status indicators for network ports on the front panel are:
Green—Port is set to full-duplex mode.
Unlit—Port is set to half-duplex mode.
The uplink module ports are always set to full-duplex mode;
therefore, the LED is always green.
Indicates the speed.
The speed indicators are:
Blinking green—1 Gbps
Steadily green—10 Gbps
Enter button on the LCD