Interfaces; Layer 2 And Layer 3 Protocols - Dell PowerConnect J-8208 Release Note

JUNOS 10.2 Software Release Notes
Related Topics
8
On J-EX8200 switches, if IS-IS is enabled on routed VLAN interfaces (RVIs), IS-IS
adjacency states go down and come up after a graceful Routing Engine switchover
(GRES).
Momentary loss of an inter-Routing Engine IPC message might trigger the alarm that
displays the message
Loss of communication with Backup RE
affected.

Interfaces

J-EX Series switches do not support queued packet counters. Therefore, the queued
packet counter in the output of the
always displays a count of 0 and is never updated.
The following message might appear in the system log:
Resolve request came for an address matching on Wrong nh nh:355,
type:Unicast...?
You can ignore this message.
On J-EX4200 switches, when port mirroring is configured on any interface, the mirrored
packets leaving a tagged interface might contain an incorrect VLAN ID.
On J-EX8200 switches, port mirroring configuration on a Layer 3 interface with the
output configured to a VLAN is not supported.
On J-EX8200 switches, when an egress VLAN that belongs to a routed VLAN interface
(RVI) is configured as the input for a port mirroring analyzer, the analyzer incorrectly
appends a dot1q (802.1Q) header to the mirrored packets or does not mirror any packets
at all. As a workaround, configure a port mirroring analyzer with each port of the VLAN
as egress input.
The following interface counters are not supported on routed VLAN interfaces (RVIs):
local statistics, traffic statistics, and transit statistics.
J-EX Series switches do not support IPv6 interface statistics. Therefore, all values in
the output of the show snmp mib walk ipv6IfStatsTable
count of 0.
The
show interfaces interface-name detail | extensive
counting of packets or bytes for the transit statistics and traffic statistics counters.
You can use the counter information displayed under the
the output.

Layer 2 and Layer 3 Protocols

On J-EX4200 switches, IPv6 ping is not supported for more than 64 virtual routing and
forwarding (VRF) addresses.
New Features in JUNOS Release 10.2 for J-EX Series Switches on page 3
Changes in Default Behavior and Syntax in JUNOS Release 10.2 for J-EX Series Switches
on page 5
Outstanding Issues in JUNOS Release 10.2 for J-EX Series Switches on page 9
show interfaces interface-name extensive
command always display a
command might display double
Physical interface
. There is no functionality
command
section of