Configuring The Modem - Dell PowerConnect J-EX4500 Hardware Manual

Configuring the Modem

Table 29: Port Settings
Port Settings
Bits per second
Data bits
Parity
Stop bits
Flow control
The boot process proceeds as normal and ends with a login prompt.
Before you connect the modem, you must configure the modem with required port
settings.
NOTE: The following procedure uses Hayes-compatible-modem commands
to configure the modem. If your modem is not Hayes-compatible, see the
documentation for your modem for the equivalent modem commands.
To configure the modem:
Connect the modem to the desktop or notebook computer.
1.
Power on the modem.
2.
From the computer, start your asynchronous terminal emulation application (such
3.
as Microsoft Windows HyperTerminal) and select the COM port to which the modem
is connected (for example, COM1).
Configure the port settings shown in Table 29 on page 107.
4.
In the HyperTerminal window, type
5.
The modem sends an OK response to verify that it can communicate successfully
with the COM port on your desktop or notebook computer.
To configure the modem to answer a call on the first ring, type
6.
Press Enter.
To configure the modem to accept modem-control DTR signals, type
7.
prompt. Press Enter.
To disable flow control on the modem, type
8.
To set the fixed serial port speed on the modem, type
9.
Enter.
Chapter 11: Connecting the Switch
Value
115200
8
None
1
None
at . Press Enter.
at the prompt. Press Enter.
at&k0
at the prompt. Press
at&b1
at the prompt.
ats0=1
at the
at&d1
107