Queue Management (Qm) Messages - Xerox 4850 HighLight Color Message Manual

XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE
13.
Queue management (QM) messages may appear on your system
controller display to advise you of the activities of the Queue
Manager.
This chapter lists and describes each QM message and provides
the appropriate actions to take as required. Refer to the Xerox
4850/4890 HighLight Color LPS Command Reference for more
information on system commands.
QM0050 QUEUE MANAGER IS ACTIVE
You entered the CONTINUE or CONTINUE Q command. The
system is informing you that the Queue Manager has resumed
activity from a stopped state.
Action None.
QM0060 Queue Manager is stopped
You entered the STOP or STOP Q command, causing the Queue
Manager to halt.
Action When you want the Queue Manager to resume activity, enter the
CONTINUE or CONTINUE Q command.
QM0100 Queue display mode is FULL
You entered the SET QUEUE DISPLAY FULL command. The
system is confirming the FULL option for the JOBS display.
Action None.
QM0105 Queue display mode is BRIEF
You entered the SET QUEUE DISPLAY BRIEF command. The
system is confirming the BRIEF option for the JOBS display.
Action None.
QM0115 Queue Manager is stopped
You entered the SCHEDULE or SCHEDULE SINGLE command
while the STOP or STOP Q command was in effect. The system
is confirming the scheduling mode of the Queue Manager.
Action None.
Queue management
(QM) messages
schedule mode is single
13-1