Xerox 4850 HighLight Color Message Manual page 107

XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE
OS2342 Reprinting of the entire finishing set required. Discard
incomplete set from the finisher.
Segment recovery is in effect.
Action Follow the instructions in the message and then press
CONTINUE.
OS2350 STIMING value ignored. Use FCG to set device parameters.
The system detected an STIMING command in the data stream.
The system ignores the command because the printer relies on
the operator using FCG to specify the timing parameters for the
finishing device. This message is for information only.
Action None.
OS2400 Printer misfeed detected. Check paper supply.
A paper jam occurred when paper was improperly fed from the
main tray, auxiliary feeder tray, or both.
Action Release the feeder belt and check both feeder trays. Remove
any misfed paper. Refer to the Xerox 4850 HighLight Color LPS
Operator Guide or to the Xerox 4890 HighLight Color LPS
Operator Guide for specific procedures.
OS2451 Requested bypass not on system. "CONT" defaults to bin.
Enter CONTINUE or ABORT
A job with DESTINATION=EXPORT was sent to a printer with no
Bypass Transport.
Action Press <CON> to resume input processing or to abort the job.
OS2452 Problem with segment separator save file.
The system encountered a problem while accessing the separator
page save file.
Action Correct and rerun the job.
OS2453 Invalid font index number for printable string.
The font index specified for the SNUMBER string on a separator
page is invalid.
Action Correct and rerun the job.
OPERATING SYSTEM SOFTWARE (OSS) MESSAGES
9-49