Xerox 4850 HighLight Color Message Manual page 109

XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE
OS2515 Black Housing: NOT READY
The black housing is not ready for any print jobs. This message
is followed by these messages:
OS2681 Print quality adjustment is required
OS2674 Enter PQA command
Action Enter the PQA command.
OS2516 Black Housing: INOPERABLE. Service is required.
This message indicates an IOT problem exists.
Action Contact your service representative.
OS2530 Please clean the COROTRONS now.
One or more corotrons are dirty, which could result in degraded
print quality.
Action Clean all corotrons.
OS2550 Dry ink reclaim bottle or final filter full
The container that receives excess dry ink particles during
printing is full. The printer control console displays the message
PRINTER FAULT. SEE MESSAGE AT CRT.
Action Contact your service representative to replace the container
before printing again.
OS2551 Dry ink waste container full
The dry ink waste container is full.
Action Replace the container and resume printing. Refer to the Xerox
4850 HighLight Color LPS Operator Guide or to the Xerox 4890
HighLight Color LPS Operator Guide for specific procedures.
OS2552 Dry ink waste container not present
There is no dry ink waste container in place.
Action Install a dry ink waste container and begin printing your job.
OS2553 Replace developer waste container
The developer waste container is missing.
Action Install a developer waste container. Refer to the Xerox 4850
HighLight Color LPS Operator Guide or to the Xerox 4890
HighLight Color LPS Operator Guide for specific procedures.
OPERATING SYSTEM SOFTWARE (OSS) MESSAGES
9-51