Xerox 4850 HighLight Color Message Manual page 88

OPERATING SYSTEM SOFTWARE (OSS) MESSAGES
9-30
OS1570 File protected -- unable to dump
The system cannot print dump because the file is protected by
the SECURE filename.file type command.
Action 1. Obtain the correct password and log on at level 5.
2. Retry the printout.
OS1580 Can't print Ethernet error page - missing font
A job transmitted over the Ethernet contains errors. The system
cannot print the error page because the required font was not
found on the system disk.
Action 1. Load the necessary font file to disk. Refer to the Xerox 4850
HighLight Color LPS Operator Guide or to the Xerox 4890
HighLight Color LPS Operator Guide for more information or
contact your service representative for information on the
correct font to load.
2. Restart the job.
OS1585 Can't read message file. No Ethernet error page printed
The system cannot print the error page at the end of the report
transmitted over the Ethernet because the required message file
is missing.
Action Contact your service representative.
OS1590 Generating Ethernet error page
The job transmitted over the Ethernet contains errors. The
system is compiling an error page to print at the end of the job.
Action 1. Check the Ethernet error page for the location of errors in
the job.
2. Recreate the job if necessary.
OS1600 INPUT task not active.
You entered the STOP I command when no job had been sent
or started.
Action None.
OS1610 OUTPUT task not active.
You entered the STOP O command or pressed the Stop button
while the system was not printing.
Action None.
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE