Xerox 4850 HighLight Color Message Manual page 64

OPERATING SYSTEM SOFTWARE (OSS) MESSAGES
9-6
OS0801 NVM update complete.
The system completed the periodic acquisition of information
from the printer control console.
Action None.
OS0820 Paper Tray: 0 1 2
This message is displayed if you entered the PQA command, or
entered it with parameters other than START or CANCEL. Zero
(0) indicates the paper tray number, one (1) indicates either
simplex or duplex, and three (3) indicates either 'stop before
printing' or 'continue job automatically.'
Action None.
OS0821 Cluster: 0 1 2
This message is displayed if you entered the PQA command, or
entered it with parameters other than START or CANCEL. Zero
(0) indicates the paper tray number, one (1) indicates either
simplex or duplex, and three (3) indicates either 'stop before
printing' or 'continue job automatically.'
Action None.
OS0830 Attention light enabled
The system accepted your LIGHT ENABLE command.
Action None.
OS0831 Attention light disabled
The system accepted your LIGHT DISABLE command.
Action None.
OS0840 BLADE IS ENABLED
The system enabled the transfer assist blade.
Action None.
OS0841 BLADE IS DISABLED
The system disabled the transfer assist blade.
Action None.
OS0845 Exiting lockout mode
The system terminated the lockout diagnostic mode.
Action None.
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE