Xerox 4850 HighLight Color Message Manual page 202

QUEUE MANAGEMENT (QM) MESSAGES
13-10
QM2660 Print file is saturated
A report in the queue was held because a required resource was
not available. The Queue Manager immediately schedules this
report for printing and the system displays the following
message:
QM1066 Scheduling entry n
Action None.
QM2715 Command ignored, retry later
You entered a command other than the INITIALIZE QUEUE
command when the Queue Manager was running in a degraded
mode. The following messages display:
QM2715 Command ignored, retry later
QM1450 Queue Manager is functioning in a degraded mode
QM2200 Run COMPRESS and INITIALIZE QUEUE
Action 1. Delete files from the disk or run COMPRESS to make more
space available.
2. Enter the INITIALIZE QUEUE command.
QM2750 Job not found. Check & retry
You entered the ABORT or CANCEL command specifying a job
identification (id) number the system could not find.
Action Reenter the command specifying the correct job number.
QM7950 Print file management failure
The print file on the system disk was left in a state that makes it
unusable.
Action 1. Enter the RESET command.
2. Enter the REALLOCATE command and follow directions on
the display.
3. Restart the job.
QM8900 Unable to load printing software
This message displays when the Queue Manager cannot
successfully load the INPUT and OUTPUT tasks. System failure
occurs following this message.
Action Restart the system and resubmit the job.
QM9010 Insufficient space to create the queue.
The system does not have enough space to create a queue of
200 entries.
Action Check your space requirements to allow for database creation.
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE