Table of Contents
Advertisement
OPERATING SYSTEM SOFTWARE (OSS) MESSAGES
9-114
OS9700
Error detected while going offline.
An error occurred in the online interface as the system was going
offline.
Action
1. Press the Boot button and enter B to reboot the system.
2. Enter the ONLINE command.
3. Enter the OFFLINE command.
4. If the problem recurs, contact your service representative.
OS9800
Hardware error/disk-INPUT. Call for service.
The system detected a system disk error during the input
process.
Action
1. Restart the job.
2. If the problem recurs, contact your service representative.
OS9900
System cannot go "ONLINE".
An error occurred in the online interface as the system was going
online in response to your ONLINE command.
Action
1. Reenter the ONLINE command.
2. If the problem recurs, contact your service representative.
OS9910
System cannot go "READY".
An error occurred in the online interface as the system was going
online in response to power-up.
Action
1. Repeat the power-up sequence. Refer to the Xerox
4850/4890 HighLight Color LPS Operator Guide for more
information.
2. If the problem recurs, contact your service representative.
OS9920
No system log. Call for service
The system could not find the error log for the current job.
Action
1. Enter the PROBLEM command to initialize the error log.
2. Run the job again.
3. If the problem recurs, contact your service representative.
OS9930
SCSI disk read error
The system detected a SCSI disk error.
Action
Contact your service representative.
OS9950
Memory is too degraded to use. Call for service.
The system memory is insufficient to run the job, even in a
degraded mode.
Action
1. Press the Boot button and enter B to reboot the system.
2. If the problem recurs, contact your service representative.
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE
Advertisement
Table of Contents
