Xerox 4850 HighLight Color Message Manual page 97

XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE
OS1970 FCG exiting: Unable to run during a print job
FCG is verifying that the input or output tasks are inactive before
beginning its activities.
Action Make sure the system is idle, then retry FCG.
OS1971 FCG exiting: FCG.LIB not present on the system
The system cannot find the requested FCG.LIB file that contains
the profiles of the FCG.
Action 1. Verify the .LIB name and retry the command.
2. If the message reappears, contact your service representative.
OS1972 FCG exiting: Finishing device profile name not found.
or
FCG exiting: Unable to locate profile name
The specified FCG.LIB does not contain the profile name you
requested. Message OS1976 follows.
Action 1. Verify the profile name and retry the command.
2. If the message reappears, contact your service representative.
OS1973 FCG exiting: Duplicate profile entries
The system found a profile name with the same name you have
specified. Message OS1976 follows.
Action 1. Verify the profile name and retry the command.
2. If the message reappears, contact your service representative.
OS1974 FCG exiting. Profile for profile-name successfully loaded.
FCG completed its tasks successfully.
Action None.
OS1975 FCG exiting: Unable to communicate with printer.
Profile not loaded
A connection between FCG and the LPS failed three times.
Message OS1976 follows.
Action Contact your supervisor or systems support specialist.
OS1976 FCG exiting: Invalid profile encountered.
The system cannot accept the parameters or values you have
entered. You may have entered syntax or characters incorrectly.
Action 1. Verify that your values and syntax are correct and retry the
command.
2. If the message reappears, contact your service representative.
OPERATING SYSTEM SOFTWARE (OSS) MESSAGES
9-39