Table of Contents
Advertisement
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE
PRINTER SUBSYSTEM CONTROLLER (PSC) COMMAND MESSAGES
PS9016
***Fatal Error*** CRIB firmware has incorrect checksum
The system detected incorrect content in the firmware file.
Action
1. Enter the PSC CRIB command.
2. If the message reappears, perform a sysgen or DSR restore.
3. If the problem persists, contact your service representative.
PS9017
***Fatal Error*** Unable to download CRIB FW
The system cannot download the firmware file.
Action
1. Enter the PSC CRIB command.
2. If the message reappears, perform a sysgen or DSR restore.
3. If the problem persists, contact your service representative.
PS9018
***Fatal Error*** Unable to obtain checksum from CRIB
The system could not receive checksum from the firmware on
CRIB.
Action
1. Enter the PSC CRIB command.
2. If the message reappears, perform a sysgen or DSR restore.
3. If the problem persists, contact your service representative.
PS9019
***Fatal Error*** Unable to execute CRIB FW
The system could not receive a successful response after issuing
an execute firmware command.
Action
1. Enter the PSC CRIB command.
2. If the message reappears, perform a sysgen or DSR restore.
3. If the problem persists, contact your service representative.
PS9020
***Fatal Error*** Problem with SCSIHP.SYS file
The system could not find the SCSIHP.SYS file.
Action
1. Make sure your SCSIHP.SYS file is in the system.
2. If the message reappears, perform a sysgen or DSR restore.
3. If the problem persists, contact your service representative.
PS9030
***Fatal Error*** No header on SCSIHP.SYS file
The SCSIHP.SYS file has an incorrect header, and the file is
corrupted.
Action
1. If the message reappears, perform a sysgen or DSR restore.
2. If the problem persists, contact your service representative.
PS9031
SCSI device not installed in system.
The system could not find the enhanced SCSI controller.
Action
Contact your service representative.
12-7
Advertisement
Table of Contents
