Table of Contents
Advertisement
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE
OS2810
Start-up message from job tape follows:
This message appears in a single report mode. The system also
displays a report delimiter or forms information message.
Action
Watch the console display at the printer for additional
information.
OS2811
The following is a document-generated job-start message:
The system displays this informational message prior to printing
the job.
Action
None.
OS2812
The following is a document-generated job-end message:
The system displays this informational message after printing the
job.
Action
None.
OS2820
Task not allowed till system status = 'IDLE'.
The system must be offline to process the requested task. This
message also appears if you pressed the REWIND command or
pressed the Rewind button while a tape job is printing.
Action
1. Wait until the tape job completes before rewinding the tape,
or complete or abort any current jobs.
2. Enter the OFFLINE command.
3. Reenter the command to run the task.
OS2821
Task not allowed until report queue is empty
You entered a command to engage a utility while a job was
printing. The system cannot process the command you entered
until the report queue is empty.
Action
Retry the command when the report queue is empty.
OS2822
Do a RESET before retrying operation.
You must reset the system before it can process the command
you entered.
Action
1. Press the Reset button or enter the RESET command.
2. Retry the operation.
OPERATING SYSTEM SOFTWARE (OSS) MESSAGES
9-61
Advertisement
Table of Contents
