Table of Contents
Advertisement
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE
FL2601
Duplicate using existing floppy image? (Y/N)
The floppy duplicate (FLF DUP) command you entered was
aborted, and the information from the source floppy disk was
saved in a file. You can write the file to a target floppy disk
without reading the source file by entering the FLF DUP
command again.
Action
Perform one of the following actions:
•
Enter Y to proceed with the FLF DUP command.
•
Enter N to cancel the operation.
FL2602
Do you want another copy of the same floppy? (Y/N)
You are requested to decide if you want to make another copy
of the floppy disk currently in the drive.
Action
Perform one of the following actions:
•
Enter Y to make another copy.
•
Enter N to cancel the operation.
FL2603
Do you want to duplicate another floppy? (Y/N)
You are requested to decide if you want to make a copy of a
floppy disk that is not currently in the drive.
Action
Perform one of the following actions:
•
Enter Y to make another copy.
•
Enter N to cancel the operation.
FL2604
Do you want to save the image of the source floppy? (Y/N)
The system is prompting you to verify whether you want to save
a copy of the source floppy disk to a file on the disk for use
when you reenter the FLF DUP command after an aborted
attempt.
Action
Perform one of the following actions:
•
Enter Y to copy the source floppy disk onto the disk.
•
Enter N to cancel the operation.
FL2605
Are you sure you want to continue
You are requested to verify whether you want the system to
erase all the existing files on the floppy disk.
Action
Perform one of the following actions:
•
Enter Y to erase all the files from the floppy disk.
•
Enter N to cancel the operation.
GENERAL FLOPPY UTILITY (FLF) MESSAGES
5-9
Advertisement
Table of Contents
