Xerox 4850 HighLight Color Message Manual page 200

QUEUE MANAGEMENT (QM) MESSAGES
13-8
QM1750 Entry name cannot be moved or scheduled.
The entries you specified with the SCHEDULE or MOVE
command do not have a QUEUED or HELD status.
Action Reenter the command using the correct entry string.
QM1826 Warning flag is n and frequency flag is n
This message confirms the state of the frequency and warning
flags you specified with the INITIALIZE QUEUE or CLEAR QUEUE
commands. Warning flags indicate that the logical end of the
queue database is approaching. Frequency flags determine how
often the system displays warning messages.
Action None.
QM2000 Enter CONTINUE to resume printing
The Queue Manager cannot schedule any reports to OUTPUT
now. The system resumes when you take the corrective action
specified by these preceding messages:
QM2010 Change housing or
QM2020 Enter appropriate SUB INK command or
QM2025 Enter STITCH OFF if stitcher is not functional
Action Perform the corrective actions indicated by preceding messages.
Then enter the CONTINUE command to resume printing.
QM2001 Choose a smaller number of entries
The Queue Manager enters an initialization phase every time you
boot the system. If errors occur while the system is creating files
QUE.SYS and QMGR.SYS, the following messages display:
QM1245 n initialization failure, printing inoperative.
QM1553 Insufficient file space for a queue of n entries
QM2001 Choose a smaller number of entries
These messages also display if you used the INITIALIZE QUEUE
command, and not enough disk space is available to create the
file QUE.SYS.
Action Perform one of the following actions:
• Delete files from the disk or run COMPRESS to make more
space available for the queue database files.
• Enter the INITIALIZE QUEUE command specifying a smaller
number of entries.
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE