Xerox 4850 HighLight Color Message Manual page 164

OPERATING SYSTEM SOFTWARE (OSS) MESSAGES
9-106
OS8860 Page format error. Page will not be printed.
The job has improper metacodes.
Action 1. Retry the job.
2. If the message reappears, check the software package that
emits the metacode to make sure you are using the current
level of software.
3. If the problem continues, contact your service representative.
OS8950 Insufficient dynamic memory to run requested task.
Not enough dynamic memory remains to load the requested
task. Memory was reported as inoperable during the system
boot, or the system disk file of the task was modified.
Action 1. Reboot the system by pressing the Boot button and entering
B.
2. Restart the job.
3. If the problem continues, resysgen the disk if you are
authorized to do so. If you are not, contact your service
representative.
OS8960 File management initialization failure - reboot
The system failed in its attempt to initialize file management
processing.
Action Reboot the system.
OS8970 Cannot open recovery file.
The automatic job recovery file that contains data necessary to
recover after a system rollover was left in such a state that it
cannot be accessed.
Action Resysgen the disk to recreate the file, if you are authorized to do
so. If you are not, contact your service representative.
OS8980 Unable to initiate INPUT task.
The system cannot find or read the input task you requested.
Action 1. Enter the RESET command.
2. Restart the job.
3. If the message reappears, reboot the system by pressing the
Boot button and entering B.
4. If the problem continues, resysgen the disk if you are
authorized to do so. If you are not, contact your service
representative.
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE