Xerox 4850 HighLight Color Message Manual page 16

DISK SAVE AND RESTORE (DSR) COMMAND MESSAGES
3-2
DS2020 Mount ready DSR volume nnn
The DSR process requires more than one save tape. The system
encountered the end of volume (EOV) label.
Action Mount the additional save tape.
DS3010 Invalid parameter . . . DSR aborted
You entered an incorrect density parameter with the DSR
command. The system terminated the DSR task.
Action Reenter the command as DSR or DSR 6250. No other
parameters are accepted.
DS8010 Tape error n . . . DSR aborted
The system encountered a device error from which it was unable
to recover after several attempts. The system terminated the
DSR task.
Action 1. Clean the tape drive and retry the task. Refer to the Xerox
4850/4890 HighLight Color LPS Operator Guide for
instructions.
2. If the problem continues, replace the save tape.
DS8030 Tape is write protected
The save tape does not have a write-enable ring. The system
cannot copy data to the tape and aborts the DSR task.
Action 1. Add a write-enable ring to tape.
2. Reenter the DSR command.
DS8040 6250 not supported, defaulting to 1600
You entered the DSR command, but your system does not
support a recording density of 6250 bpi. The system will record
at 1600 bpi.
Action None.
DS9010 Disk error n . . . DSR aborted
The system encountered a disk error from which it was unable to
recover after several attempts. The DSR task is aborted.
Action Contact your service representative.
DS9020 DSR aborted
The DSR task aborted due to a hardware error.
Action 1. Retry the DSR task.
2. If the problem continues, contact your service representative.
XEROX 4850/4890 HIGHLIGHT COLOR LPS MESSAGE GUIDE